Stainless Steel Sterilization Pouch Sealer 500 W, 250 mm Seal Width (430×340×250 mm)

Product details

This device is used to seal pouches for the sterilization of dental instruments.

Its advantages are: robust device, safe and simple operation, low-maintenance, attractive design.

The housing is made of stainless steel, easy to clean, corrosion-resistant.

The sealer is intended for use in dental clinics and practices.

Key features: depending on the size of the pouches, the device adjusts the optimal sealing temperature. It has two blades for high-quality cutting.

Directions for use: Connect the device to an AC230V/50Hz power source. Turn the device on with the main switch. The device will take 2 minutes to preheat. You can start using the sealer when the indicator LED goes off. There are two holes on both sides of the device for installing the pressure bar. When the indicator LED goes off, the device is ready for use. For the optimal sealing temperature and correct sealing, the temperature control knob should be set between point 3 and 4. The sterilization roll should be placed between the pressure bar and the sealing bar with the transparent side up. Pull the lever and keep pressing it down until the sterilization pouch is properly sealed. After sealing, cut the pouch by sliding the round knob at a constant speed. If you cut the pouch too fast or too slowly, it will not be cut correctly. The end of the sterilization roll is inserted from the back onto the support rod, bringing the end of the roll out between the pressure bar and the sealing bar. With the transparent side up and making sure the paper roll stays firmly in position, pull it until it reaches a sufficient length for the instrument to be sterilized. Then seal and cut the pouch.